Error: Open:the company is owned by a PVSW engine running on

Questions regarding Pervasive Issues and error messages.

Error: Open:the company is owned by a PVSW engine running on

Postby Customer Service » January 14th, 2012, 3:28 am

This message is the translation of Pervasive error code 116. There can be a number of different reasons for that so it is not easy to jump to a single solution. In theory, this message could occur in a Pervasive Client/Server installation, but that is unlikely. It generally will be in a 3-user Workgroup environment.

Solution:

1. Make sure the Pervasive Database - Pre-load engine starts automatically on each computer. That is, immediately after doing a Windows Restart you should be able to see the engine icon in the System Tray/Notification Area on Taskbar.
2. You should be able to right-click and select About. If this is not the case, then the Pervasive install was incomplete to some degree.
3. Make sure that you can ping between the computers by name. If there is a computer designated as the C21 server, then it should be necessary only to be able to ping from each workstation to that computer. But it would be good to try pinging in all directions. Inability to ping could indicate that the TCP/IP network protocol properties are not configured correctly on a computer.

How to Ping:

1. On each computer right-click on My Computer and select Properties.
2. From the Computer Name tab note the computer name (not description).
3. Start a (DOS) Command Prompt window.
4. From any given computer, ping the other computers. For example, from Station3, enter the follow type commands:
ping station1
ping station2

You will see messages indicating the success of the ping.

Getting rid of Pervasive Overhead

If problems were found/corrected in the first 2 steps of the solution, this may not be necessary to solve this particular issue. However, it is generally good to do anyway. If nothing else, it could do away with some unnecessary overhead the Pervasive engine could be going through.

1. On each computer run the Pervasive Control Center. (Start/All Programs/Pervasive Group)
2. In the left pane, open the tree until you get to the <local computer> Configuration node.

Under Server, check/set the following properties:

1. Access (highlight Access in left pane, double-click Name in right pane to check/set value).
2. Accept Remote Request > set to On.
3. Communication protocols.
4. Supported protocols > make sure only Selected item is Microsoft TCP/IP.

Under Client check/set the following properties:

Access
Gateway Durability > set to: Off
Target Engine > set to Try Server, then Workstation
Use Local MicroKernel Engine > set to On
Use Remote MicroKernel Engine > set to On
Communication protocols
Supported protocols > make sure only Selected item is Microsoft TCP/IP

Exit out of the Pervasive Control Center, responding Yes when asked if you want to save configuration changes. Then Stop/Restart the Pervasive Pre-load engine (you can just restart the computer to accomplish this).
Customer Service
Site Admin
 
Posts: 318
Joined: November 15th, 2011, 1:04 am

Return to Pervasive Issues and error messages

cron